How Modern Furnace Ignition Works
Most Orland Park gas furnaces built after 1995 use a silicon carbide or silicon nitride hot surface igniter (HSI) instead of a standing pilot light. When the thermostat calls for heat, the inducer starts, the igniter glows bright orange, and the gas valve opens once ignition temperature is reached.
When an igniter develops a hairline crack—common after 4 to 7 Illinois winters—the control board sends voltage, the element never glows, and the unit locks out after three tries. Homeowners in Eagle Ridge and Tinley Park frequently see this failure during the first deep freeze.
Igniter vs. Flame Sensor Symptoms
- Bad Hot Surface Igniter: Inducer runs, no orange glow inside the burner window, burners never ignite.
- Dirty or Failing Flame Sensor: Burners light cleanly for 3–5 seconds, then immediately shut off because the board cannot confirm flame rectification.
- Standing Pilot / Thermocouple (Older Units): Common in legacy basements in Old Orland; pilot blows out or thermocouple fails to hold the gas valve open.
For a deeper homeowner walkthrough, read our igniter and flame sensor troubleshooting guide, or return to Orland Park furnace repair to book a technician.
Why Igniter Replacement Should Match OEM Specs
Some older furnaces use 120V igniters while newer models use 80V or 24V silicon nitride upgrades. Independent technicians verify voltage and amp draw before installing a replacement so the new igniter doesn't burn out prematurely.
Call (312) 834-4130 for urgent no-heat dispatch or estimate your repair range with our cost calculator.
Frequently Asked Questions
Once diagnosed, an experienced local technician can typically replace a hot surface igniter and test full ignition cycles within 45 to 60 minutes.
Lightly buffing an accessible metal flame rod with fine steel wool or a dollar bill is a common DIY step, though recurring lockouts point to wiring, grounding, or gas pressure issues.